WAVECOM CLONE SERIAL SETTINGS

By , September 3, 2014 12:21 PM

 

to connect to the serial port use putty

select the COM port and settings can be

When the port is selected click Ok, to get to the Port configuration form

On this form specify the port settings.

The most common port speeds for GSM phones and modems are 9600, 19200, 57600 and 115200.

The Data bits should be set to 8. The Parity to none the Stop bits to 1 and the flow control should be hardware.

Set the appropriate serial port (usually COM1)
Baud rate (speed) = 9600
Data bits = 8
Stop bits = 1
Parity = N

 

ENTER

AT
Will give you a response OK if you are connected

THEN
I can check in PuTTY GSM modem information using commands:
Manufacturer: AT+CGMI -> “WAYECOM MODULE”
Model: AT+CGMM -> “MULTIBAND G850/900E/1800/1900MHz”
Revision: AT+CGMR -> “652B09gg.Q2406B 1961548 103107 17:50”
IMEI: AT+CGSN

Thomas Challenger Thomas Challenger